Introduction

The BMENOR2200H module has a built-in Hyper Text Transfer Protocol Secure (HTTPS) web server that provides access to various secure web pages. Use these pages to monitor the status of the module without installing Control Expert or the module’s corresponding DTM.

Use these web pages to import, export, or delete encrypted cyber security management files.

You can monitor the security of communications through the SEC LED.

NOTE: Web page access is available only when the module is in advanced mode. Refer to the directions for configuring the appropriate level of cyber setting with the rotary switch.

Before You Begin

Use the web pages described in this chapter to apply cyber security features on the BMENOR2200H module

You can apply cyber security to the module after you satisfy these requirements:

  • If you want to configure cyber security on RTU protocol, you need to have configured at least one communications channel for the module in the Control Expert DTM.

  • You have configured the appropriate setting (Advanced) on the rotary switch.

Login

The first time you log in to advanced mode, the cyber security file is not valid. Therefore, follow these steps to configure the file:

Stage

Description

1

Log in to the web pages as an administrator.

2

Access the cyber security setting page.

3

Configure the event log with a valid IP address (or disable event log).

4

Configure a valid pre-shared key or disable DTLS in HSBY.

5

Apply the configuration to the module.