– open the UP Application
\n– add ATV device in DTM Browser (ATV9xx in EIP for instance)
\n– define a device name and an IP
\n– in the web pages connected to the drive set this IP as static
\n– then reboot the drive
\n– connect the DTM
\n– make a load data from device to be sure you’ve got the right reference
\n– configure the following points
\n– profile as Assembly 100\/101
\n– FDR as enabled stored 10s synchro
\n– CommandRefParam \/ Reference source 1 at Embedded Ethernet source
\n– input phase loss Ignore
\n– output phase loss ignore
\n– make a store data to device
\n– wait the synch is done
\n– then change the configuration of the FDR from stored to served
\n– make a store data to device
\n– rebuild all save and download to the PLC<\/p>\n","protected":false},"excerpt":{"rendered":"
– open the UP Application – add ATV device in DTM Browser (ATV9xx in EIP for instance) – define a device name and an IP – in the web pages connected to the drive set this IP as static – then reboot the drive – connect the DTM – make a load data from device … <\/p>\n